Majority
Headnote
Master and Servant—Defective Appliances.The defendant is a corporation owning and operating a blast lurnace. As a part of this furnace, used for the purpose of heating the draft of air forced into it, called the “blast,” is a “stove” or “ oven,” so called. This stove or oven is a large stack or chimney of iron, some 70 feet high and 16 feet in diameter, divided into four apartments. The largest apartment is occupied from top to bottom with a large number of small fire brick flues or chimneys, without lateral connections. It is operated by conducting gas into the oven; the gas is ignited, passes up through the apartments not occupied by the fire brick flues, to the top of the flues, passes over and is drawn down through the fire brick chimneys or flues, and is drawn out or escapes by a chimney valve. By this process the fire bricks are heated to 900 or 1,000 degrees Fahrenheit. When they have been so heated the gas is shut off, what is called a “blast valve” opened, and air forced by powerful ■ engines through these heated passages in the oven, and is heated by the fire brick to a temperature of from 900 to 1,000 degrees. Then it is conducted through an opened blast valve into the furnace, furnishing what is called a “hot blast.” This blast valve is located at the bottom of the stove of oven,'on its front. It works vertically across a horizontal pipe, and is raised by means of compressed air admitted into a cylinder underneath a piston directly above the blast valve, and connected with it by the piston rod and a valve stem, which are joined together by a toggle joint. The admission of air to the piston is controlled by wdiat is called a “four-way cock;” that is, a cock with openings 90 degrees apart. The four-way cock is operated by a lever some 14 inches long. When the lever is horizontal no pressure can enter above or below the piston. When the lever is depressed about 45 degrees, air is admitted under the piston, and the blast valve is raised. When the lever is raised 45 degrees, air is admitted above the piston, and a downward pressure is obtained, which tends to keep the blast valve closed. There is a nut on the four-way cock, which may be tightened or loosened. Tightening the nut increased the friction or difficulty in moving the lever, and is intended to be used for that purpose. The men in charge of the furnace control the ease or difficulty of moving the lever by the use of this nut. This nut would naturally tend to work loose. The evidence shows that a month or six weeks before the accident this nut was tightened up; complaint was made that it was too tight, but no change was made. I cannot
No positive act of negligence on the part of the defendant is shown. Neither do I see that there is anything that it omitted to do that the law required it to do. It furnished a good machine, reasonably safe to operate. The manner of operating it, the turning on and off of the blast, the cleaning of the oven, the handling of the lever, were all matters of detail, which must necessarily be looked after by its employes, and rested upon their care, intelligence, and fidelity. Cullen v. Norton, 126 N. Y. 1 , 26 N. E. Rep. 905 ; Filbert v. Canal Co., 121 N. Y. 207 , 23 N.
The judgment should be affirmed, with costs. All concur.
Cases cited
- Cullen v. Norton 126 N. Y. 1 at 26 p. 457
- Filbert v. President, Managers and Co. of the Delaware & Hudson Canal Co. 121 N. Y. 207 p. 457
- Burke v. Witherbee 98 N. Y. 562 p. 458